Product Details

Keep your Falco eDrive cool under load

Hx-Kool is a magnetic cooling fluid for Falco eDrive direct-drive hub motors. Injected into the motor's air gap, it is held in place by the motor's own magnets and gives heat a direct path from the windings to the shell. The result is a cooler-running motor on long climbs, heavy loads, tandems and hot days.

5 mLONE SYRINGE, ONE MOTOR
Ø 1.5 mmFILL HOLE
89 mmFROM AXLE CENTRE
~15 minTO INSTALL

How it works

Air is a poor conductor of heat, so the thin gap between the stator and the magnets acts like a blanket around the windings. Hx-Kool fills that gap with a liquid several times more conductive than air, so the heat reaches the shell and the outside air instead of building up inside the motor.

Without Hx-Kool Air in the gap traps heat in the windings N S N S N S N S Heat stays in the copper Windings HOT Rotating shell Magnets Air gap Stator+ windings With Hx-Kool Ferrofluid bridges the gap, heat reaches the shell N S N S N S N S Heat flows out through the shell Windings COOLER Simplified section through the motor rim. Not to scale.

Why riders fit it

  • Lower winding temperatures on long climbs and heavy loads
  • More headroom before the motor reaches its thermal limit
  • Negligible drag at the recommended 5 mL
  • Stays in place: held by the motor's magnets, moving or parked
  • One-time installation, no routine top-up

What's included

  • Hx-Kool ferrofluid, 5 mL pre-filled syringe
  • Applicator tip

Fits

Falco eDrive direct-drive hub motors, including the HX 750 W motor in the f7.9 system and earlier Falco eDrives. Not for geared hub motors or mid-drives.

Installation at a glance

89 mm Ø 1.5 mm fill hole Through the cover only. Stop as soon as the bit breaks through. 89 mm circle = over the air gap Measure from the centre of the axle. Drilling tips Drill with the mark at 6 o'clock so chips fall out. Grease the bit; it catches swarf. Tape flag on the bit to limit depth. Slow speed, light pressure. Motor cover, viewed face-on. Screw pattern varies by model.
  1. Power down

    Switch off and remove the battery. Clean the motor cover.

  2. Mark and drill

    Mark a point 89 mm from the axle centre. With the mark at 6 o'clock, drill a 1.5 mm hole through the cover only.

  3. Inject

    Turn the hole to 12 o'clock. Inject 1 to 2 mL at a time, turning the wheel by hand between doses, until all 5 mL is in.

  4. Seal and ride

    Clean the area, seal the hole with foil or electrical tape, spin the wheel to check, and ride.

Read the full installation guide

Good to know. Do not exceed 8 mL in total. Wear gloves: ferrofluid stains skin, fabric and floors. Drilling the cover is permanent, so if your motor is under warranty and you are unsure, call us at 877-278-6323 first.